There was no way that I was going to throw away any of the precious Snoopy fabric scraps left over from my new Snoopy shirt. The scraps really were not large enough to make anything with, not even for a child, but I just could not bear to throw them away. So, what to do with these scraps beside stack them on the edge of the cutting table and stare at them?
Recently, I have seen several little girls peplum tops that are just adorable and I have wanted to make one. So, looking at the Snoopy fabric scraps, I decided to see if I could squeeze a little girl’s peplum top out of the pieces. The size of top I would make would be determined by the dimensions of the scraps.
I didn’t really have a pattern so I turned to the internet for ideas. The first style of peplum top I found had a circular peplum. This was out of the question. The scraps I had to work with were absolutely too small to cut a circular peplum from. The second style I found was a gathered peplum. Hmmm. I might be able to make this work with the scraps.
Now, how long should the peplum be versus the length of the bodice? I saw a variety of bodice and peplum lengths from long bodices with short peplums to short bodices with long peplums and many hi/low peplums in between while I was searching. Once again, I would need to let the dimensions of the scraps determine the length of the peplum and the bodice and the scraps would also determine how full the gathered peplum would be.
Still not having a pattern, I pulled out my favorite little girls dress pattern as a guide. Based on the size of the largest scrap, I determined that I could get a size 4 bodice front and back from the scraps as well as have a few pieces left over for the peplum. I quickly picked some yellow cotton from the stash that matched Woodstock for the lining of the bodice.
To make the peplum, I squared the remaining scraps of Snoopy fabric I had and found that I had two pieces approximately 6 inches tall by 12 inches wide and 4 pieces that were 6 inches tall by 6 inches wide. (Actually, one of the 6 by 6 inches pieces was only 5 inches wide, but I could work with that.) With a lot of seam work, I determined that I could make these scraps work out for the peplum. I would sew the two 12 wide pieces together for the front of the peplum and sew the 6 inches pieces together for the back or the peplum.
I would not be matching any of the designs in the Snoopy fabric. There was certainly not enough scraps for that, but luckily with a gathered peplum, the non-matching designs as well as the many seams that I would be sewing would just be gathered in.
Excitement for this project grew, as I saw my almost useless scraps become a little girls peplum top!
Stay tuned for the sewing of the little girl’s Snoopy peplum top.
Until then, sew forth and scrap on!